gEDA-user: PCB template?

[Jim <jim@xxxxxxxxx>]

I am designing a couple of boards (if successful more than 2) that have 
the same "form factor".  That is they are the same physical size and 
both (all) have fingers to plug into a card slot on a mother board.  So 
I don't have to worry about registration of the fingers each time I come 
up with a new board, is there a way I can define a PCB template that 
includes the fingers?  That seems like it would be hard to do since the 
fingers are a connector on the schematic and wouldn't line up right 
without some tricks.  The other option might be if there were a command 
line to PCB that I could execute to tell it "put pin 1 of conn1 at X, 
Y".  Or would it be best to have a template that has a target in silk to 
line the fingers up? 

I'm open to the simplest solution.

Thanks,
Jim.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user