Re: gEDA-user: Connecting to vias

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Sat, 2010-04-24 at 22:42 +0100, Peter Clifton wrote:
> On Mon, 2010-04-19 at 20:59 -0400, George M. Gallant wrote:
> > 
> >    the fab house requirements so getting this message is annoying.
> >    Thanks for the tip on making sure to be centered on the part when
> >    performing the change sides function.
> >    Using version 20091103. 
> 
> I think you need to select the thermal tool ("THRM"), make sure you're
> editing on the layer you want to join the via / pin / pad to, and click
> on the via.
> 
> Shift + Click cycles through various different thermal styles.

Re-reading, I'm not sure I understood your problem correctly, sorry if
the above reply wasn't helpful.

If you're still having issues, check your layer stack-up looks correct
for the board, and perhaps post a (small) screen-shot, or if its not
confidential, the problem board file - and someone will take a look.

Regards,

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)
Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user