[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: L-shaped pad; Comments in fp file?

> OK, so for these two overlapping entries, Clearance should be zero,
> and the Mask should be (at least) the full width of the pads?

They should each get the right clearance/mask values as if you were
putting in just one pad.  PCB will do the right thing with them.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user