Re: gEDA-user: gsch2pcb stuck

["Robert Butts" <r.butts2@xxxxxxxxx>]

I'm all set.  I just got them from gedasymbols.org

Thanks

On Sun, Aug 17, 2008 at 6:47 PM, Stuart Brorson <sdb@xxxxxxxxxx> wrote:

I seem to recall that M4 gets stuck on footprint names with a - in
them.  Try TO18 or TO_18.

Stuart

On Sun, 17 Aug 2008, Robert Butts wrote:

> I think the problem is in the footprints.  For to TO-18 I wrote TO-18 and
> I'm thinking gsch2pcb is getting stuck there.
>
> On Sun, Aug 17, 2008 at 6:25 PM, <phil@xxxxxxxxxxxxx> wrote:
>
>>> I'm trying to run a very simple schematic thru gsch2pcb and it's getting
>>> stuck.  The printout says: using the m4 processor for pcb footprints
>>
>> Are you using newlib (file type) or M4 footprints?  I rename the directory
>> for  the M4 stuff and only use newlib footprints that I create.
>>
>> Does gsch2pcb stop at a point and tell you the results of it's job?
>>
>>> Aside
>>> from that it's just a thru hole definition.  Any ideas?
>>
>> This shouldn't make any difference.
>>
>> Phil
>>
>>
>>
>> _______________________________________________
>> geda-user mailing list
>> geda-user@xxxxxxxxxxxxxx
>> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
>>
>


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user