Re: gEDA-user: PCB Lockup/Optimization

[DJ Delorie <dj@xxxxxxxxxxx>]

Ok, I think I know what's happening, but I don't know how you got to
that point.

There's a via at 47.43mm, 18.54mm.  It appears to serve no purpose, as
it has only lines from layer two connecting to it.

However, *under* the via is a tiny copper trace on layer 1 (make vias
invisible and you'll see it, but it does stick out a little on the
side).  At least, so it seems.  It turns out you have *1500* tiny
copper traces under that via.

So, shut off layer 2, use a rectangular selection box to grab all
those traces and the via, and delete them.  Then mitering works fine.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user