[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: Vias/Masked

To: geda-user@xxxxxxxxxxxxxx
Subject: Re: gEDA-user: Vias/Masked
From: DJ Delorie <dj@xxxxxxxxxxx>
Date: Mon, 4 Dec 2006 12:51:39 -0500
Delivered-to: archiver@seul.org
Delivered-to: geda-user@moria.seul.org
Delivery-date: Mon, 04 Dec 2006 13:44:07 -0500
In-reply-to: <BAY130-F18EB3DC52A4EB55429686AD9DF0@phx.gbl> (mehansen10@hotmail.com)
List-archive: <http://www.seul.org/pipermail/geda-user>
List-help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-id: gEDA user mailing list <geda-user.moria.seul.org>
List-post: <mailto:geda-user@moria.seul.org>
List-subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
References: <BAY130-F18EB3DC52A4EB55429686AD9DF0@phx.gbl>
Reply-to: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Sender: geda-user-bounces@xxxxxxxxxxxxxx

> In PCB it shows the relief around the mask if I use the'k' command.  
> However, when the gerbers are generated there is no relief in the mask 
> around the pads.

Odd, because I have a physical board in front of me with unmasked vias
on it, so it was right at one point.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

Follow-Ups:
- Re: gEDA-user: Vias/Masked
  - From: Mike Hansen

References:
- Re: gEDA-user: Vias/Masked
  - From: Mike Hansen

Prev by Author: Re: gEDA-user: Gschem printing style chang (20060123 to 20060906)
Next by Author: Re: gEDA-user: Vias/Masked
Previous by thread: Re: gEDA-user: Vias/Masked
Next by thread: Re: gEDA-user: Vias/Masked
Index(es):
- Author
- Thread