[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: gerber to .dxf converter

To: n6nz@xxxxxxxx, geda-user@xxxxxxxxxxxxxx
Subject: Re: gEDA-user: gerber to .dxf converter
From: DJ Delorie <dj@xxxxxxxxxxx>
Date: Sat, 9 Dec 2006 00:53:22 -0500
Delivered-to: archiver@seul.org
Delivered-to: geda-user@moria.seul.org
Delivery-date: Sat, 09 Dec 2006 00:54:17 -0500
In-reply-to: <457A4B6D.2080200@arrl.net> (message from Dave N6NZ on Fri, 08 Dec 2006 21:36:45 -0800)
List-archive: <http://www.seul.org/pipermail/geda-user>
List-help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-id: gEDA user mailing list <geda-user.moria.seul.org>
List-post: <mailto:geda-user@moria.seul.org>
List-subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
References: <457A4B6D.2080200@arrl.net>
Reply-to: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Sender: geda-user-bounces@xxxxxxxxxxxxxx

> of relying on the check plot and the inherent precision limitations
> of PostScript.  Or perhaps I underestimate the check plots?

PCB's Postscript is stroked, with as much resolution as the gerbers.
They should be fine, as long as you don't rasterize them during any
interim steps.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

Follow-Ups:
- Re: gEDA-user: gerber to .dxf converter
  - From: phil@xxxxxxxxxxxxx

References:
- gEDA-user: gerber to .dxf converter
  - From: Dave N6NZ

Prev by Author: Re: gEDA-user: PCB fab supplies -- drills
Next by Author: Re: gEDA-user: gerber to .dxf converter
Previous by thread: gEDA-user: gerber to .dxf converter
Next by thread: Re: gEDA-user: gerber to .dxf converter
Index(es):
- Author
- Thread