Re: gEDA-user: Mask clearences on vias

["Harold D. Skank" <skank54@xxxxxxxxx>]

DJ,

Thanks for the info, that took care of the problem.

	Harold Skank

On Tue, 2006-12-19 at 20:10 -0500, DJ Delorie wrote:
> > I'm running the 20060907 release of the gEDA tools.  I'm getting
> > complaints from board houses that the vias placed on the board
> > (either auto or manual) have no solder mask clearance (i.e. the vias
> > and the mask diameters are the same).
> 
> Have you tried viewing the mask?  Just enable the mask layer and you
> can see the masks, and when the mask is visible you can edit the masks
> with the clearance keys (k, Shift-k, Alt-k, Alt-Shift-k).
> 
> Most vias should have mask over them (tented) or have sufficient
> clearance (like pads).
> 
> 
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user