Re: gEDA-user: Ground-plane in Pcb

[DJ Delorie <dj@xxxxxxxxxxx>]

> I got cvs but it failed to make completely. The current cvs is missing 
> some .pngs  in the ./doc dir, namely  puller.png and thermal.png

FAQ.  Disable the docs: ./configure --enable-doc=no

> But, I thought the binary might be ok, anyway. And, it does seem to
> work.  Shows version 1.99u instead of 20060822.  It seems no better
> and it did not make isolation islands over existing nets.

Try this: Draw a line top to bottom, cutting the board in half.  Now
draw a small rectangle overlapping the line.  If the clipper is
working, it should only show you one half of the rectangle.  If not,
you get two rectangles - one on each side of the line.

Also, do "File->About" and make sure you're running the binary you
think you're running ;-)


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user