gEDA-user: PCB footprint - 2 sided part

["Ostheller, Joel A. " <JOEL.A.OSTHELLER@xxxxxxxx>]

Can I get some tips on how I would create a footprint for this SMA right
angle connector that lives on both sides of the board? Should I create it
with through holes? Should I create two footprints and just make sure to
line them up? Perhaps I should have picked an easier part to do my first
footprint?  Very not obvious. 

http://emersonnetworkpower.com/webapp/wcs/stores/servlet/ESC/resources/14207
11821.pdf




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user