[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

RE: gEDA-user: PCB footprint - 2 sided part



Thanks for the help! 

-Joel

> -----Original Message-----
> From: geda-user-bounces@xxxxxxxxxxxxxx [mailto:geda-user-
> bounces@xxxxxxxxxxxxxx] On Behalf Of John Luciani
> Sent: Wednesday, December 27, 2006 3:31 PM
> To: gEDA user mailing list
> Subject: Re: gEDA-user: PCB footprint - 2 sided part
> 
> On 12/27/06, Ostheller, Joel A. <JOEL.A.OSTHELLER@xxxxxxxx> wrote:
> >
> >
> > Can I get some tips on how I would create a footprint for this SMA right
> > angle connector that lives on both sides of the board? Should I create
> it
> > with through holes? Should I create two footprints and just make sure to
> > line them up?
> 
> A footprint can have pads on both sides of the PCB. You can also overlay
> pads and a pin to get the loollipop(?) at the end of the outer pads.
> The footprint below shows top and bottom pads and should match the
> first part in the spec table.
> 
> (* jcl *)
> --
> http://www.luciani.org
> 
> Element[0x0 "Coax" "" "" 0 0 0 0 0 100 0x0]
> (
>    Pad[0 -5500 0 5500 9000 2000 11000 "" "1" 0x0100]
>    Pad[0 -5500 0 5500 9000 2000 11000 "" "1" 0x0180]
>    Pad[-17000 -5250 -17000 5250 9500 2000 11500 "" "2" 0x0100]
>    Pad[-17000 -5250 -17000 5250 9500 2000 11500 "" "2" 0x0180]
>    Pad[17000 -5250 17000 5250 9500 2000 11500 "" "2" 0x0100]
>    Pad[17000 -5250 17000 5250 9500 2000 11500 "" "2" 0x0180]
> )
> 
> 
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user