Re: gEDA-user: printing solder layer only, mirrored

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Sat, 2007-12-01 at 13:20 -0500, tj wrote:
> How do I print only the solder layer mirrored? I don't need to print all 
> 9/10 pages everytime.

Not what you asked, I know, but for UV exposure / toner transfer, isn't
the solder side best printed un-mirrored? (And the component side
mirrored), such that ink / toner touches the board / photo-resist as
close as possible?

If its for looking at the board on paper as if its the real bottom of
the board, I understand however.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user