Re: gEDA-user: gEDA for mass production?

[Steve Meier <smeier@xxxxxxxxxxxxxxxxxxx>]

Ff you select export bom an xy file will be generated. This can be used
for programing the pick and place equipment. However, it is not
suffiecent for programming a flying probe tester which need the
locations of each pin and cleared via.

Steve Meier

On Mon, 2007-12-03 at 21:17 +0000, Stefan Salewski wrote:
> Hello,
> 
> til now I only did hand soldering of prototypes.
> 
> But I am curious, can gEDA (pcb) data be used for automatic placement
> and soldering of boards? (This may be a stupid question, but currently I
> do not know which data board manufactures use for placement of devices.)
> 
> Best regards
> 
> Stefan Salewski
> 
> 
> 
> 
> _______________________________________________
> geda-user mailing list
> geda-user@xxxxxxxxxxxxxx
> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user