Re: gEDA-user: gerbv

["Ian Chapman" <ian.chapman@xxxxxxxx>]

-----Original Message-----
From: Peter Clifton [mailto:pcjc2@xxxxxxxxx] 
Sent: Thursday, December 13, 2007 11:04 AM
To: ian.chapman@xxxxxxxx; gEDA user mailing list
Subject: Re: gEDA-user: gerbv


On Thu, 2007-12-13 at 10:20 -0500, Ian Chapman wrote:
> I have noticed a minor difference between gerbv under Linux and Viewmate
9.8
> under XP.  The unplated-drill.cnc loads and displays under Linux but under
> XP gives ---Warning - syntax error M4BINC?H,TZT12C0.170%*.  I have pasted
> the unplated drill file on the tail of this post.

I wonder if you need windows line-feeds (\r\n) rather than Unix (\n) for
feeding the Viewmate program?

Try running the output through the unix2dos command

(apt-get install tofrodos)
I'll give it a try tonight.  The silkscreen and all other files load on both
applications.  It is only the drill stuff that fails on the XP system.  The
fab people are happy with the gEDA files.  I'll report on the board once I
see it.  Regards Ian.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user