[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: gEDA-user: gerbv
On Thu, 2007-12-13 at 10:20 -0500, Ian Chapman wrote:
> I have noticed a minor difference between gerbv under Linux and Viewmate 9.8
> under XP. The unplated-drill.cnc loads and displays under Linux but under
> XP gives ---Warning - syntax error M4BINC?H,TZT12C0.170%*. I have pasted
> the unplated drill file on the tail of this post.
I wonder if you need windows line-feeds (\r\n) rather than Unix (\n) for
feeding the Viewmate program?
Try running the output through the unix2dos command
(apt-get install tofrodos)
--
Peter Clifton
Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA
Tel: +44 (0)7729 980173 - (No signal in the lab!)
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user