RE: gEDA-user: PCB : multiple polygons/planes on ground solder

["Ostheller, Joel A. " <JOEL.A.OSTHELLER@xxxxxxxx>]

> -----Original Message-----
> From: geda-user-bounces@xxxxxxxxxxxxxx [mailto:geda-user-
> bounces@xxxxxxxxxxxxxx] On Behalf Of Simon_T
> Sent: Tuesday, February 20, 2007 12:56 AM
> To: geda-user@xxxxxxxxxxxxxx
> Subject: gEDA-user: PCB : multiple polygons/planes on ground solder
> 
> 
> Hello,
> 
> I have read the posts on ground planes in this forum.
> 
> However i need multiple planes on the same layer.
> 1 ground plane, 1 positive supply plane and 1 negative supply plane.
> 
> How can this be done ?
> 
> best regards
> 
> Simon
> 


I use the polygon tool to create the different planes on that layer. I
think on my last board I gave about 50 mils of separation between the
planes. I then hooked up one via to each plane using the therm tool,
thus making that entire plane equal to that net. 


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user