gEDA-user: cat to chase rate (duplicate)

[Ethan Swint <eswint@xxxxxx>]

Sorry for the repost, but my previous post came up in the pick-and-place 
thread on my email reader instead of being a new thread.  (Not quite 
sure how that happened.)

How does one go about making the rats disappear when a trace is routed? 
There is always a bit of rat left between the endpoints of the pad/pin
and trace - not all of my pads line up nicely on the grid - even though
the trace overlaps the pin/pad by a substantial amount.  I had this
problem initially after installing PCB from the Fedora repositories
(compiled 2007, ~Feb), but it returned when I compiled and installed the
a more recent (2008 Feb) source.
 
Many thanks!


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user