Re: gEDA-user: cat to chase rate (duplicate)

[epswint <epswint@xxxxxxxxxxx>]

DJ Delorie wrote:
> This usually means your traces and your pads are not on the same
> layer.  Check your layer group to make sure the 'c' and 's' (component
> and solder) layers are tagged along with the layers you think are
> component and solder.
>   
This was the key - the solder and component layers (in my 2layer board) 
were assigned to groups 3-4 instead of 1-2.  Thanks.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user