Re: gEDA-user: Read Garbage errors in gsch2pcb

[Ben Jackson <ben@xxxxxxx>]

On Sun, Feb 22, 2009 at 11:22:10PM -0500, Dan McMahill wrote:
> 
> do you still have that patch around?
> 
> Most of the footprints I would use are from the m4 library.

I've lost the patch, but the cause was forloop in common.m4 looping until
the loop var is 'equal' to the end.  There are footprints where the end
of the loop falls on X.5 because it was calculated as I/2.  Then the loop
never ends.

-- 
Ben Jackson AD7GD
<ben@xxxxxxx>
http://www.ben.com/


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user