[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: Is there a way to get a footprint to place copper on both sides?

   Kai-Martin Knaak wrote:

add the flag "onsolder" to the pad you want to put on the other side.
See page 24 of [1]http://www.brorson.com/gEDA/land_patterns_20070818.pdf

If you prefer to do footprints in the GUI of pcb, lines that are in the
"solder side" layer group, get the onsolder flag.
---<(kaimartin)>---

   Vanessa Ezekowitz wrote:

There are a couple of Commodore 64 edge connector footprints in my
[2]gedasymbols.org repository that demonstrate this also, in case that is useful
to you:
[3]http://www.gedasymbols.org/user/vanessa_ezekowitz/


   Thank you, gentlemen.  As always, this is the most helpful group.
   Jim

References

   1. http://www.brorson.com/gEDA/land_patterns_20070818.pdf
   2. http://gedasymbols.org/
   3. http://www.gedasymbols.org/user/vanessa_ezekowitz/


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user