Re: gEDA-user: Making circles in PCB

[Stefan Salewski <mail@xxxxxxxxxxxx>]

On Thu, 2010-02-25 at 13:45 -0500, DJ Delorie wrote:
> Everything in pcb supports non-90 arcs, except for the ability to
> create them.  Someone needs to come up with a friendly way to
> create/edit arcs that aren't 90 degrees, that's all.
> 

Not everything -- I think silk or copper arcs are not supported for
footprint files? And I think he was mostly concerned with footprints?

On Thu, 2010-02-25 at 11:35 -0700, Mike Bushroe wrote:
>    degree fraction as the 90 degree limit imposed by the GUI. But when
>    making foot prints for non-typical components (this time around an




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user