[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

gEDA-user: ground / power layers

Just checking before I do this…

 

To make an entire layer of a board a “ground layer”, all I would need to do is:

  1. Select correct layer from the bullets on the left hand side.
  2. Select “RECT”
  3. Draw the rectangle on the entire board which will automagically not connect to any through holes or vias
  4. Select “Line” and connect all vias and through holes.

 

Am I missing anything? Any extra tips before I start this?


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user