gEDA-user: Building the PCB+GL branch [WAS: Re: Open GL survey (for PCB)]

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Wed, 2009-01-28 at 22:13 +0000, Peter Clifton wrote:
> On Wed, 2009-01-28 at 01:11 +0000, Peter Clifton wrote:
> > Give the works so far a try:
> > 
> > http://repo.or.cz/w/geda-pcb/pcjc2.git
> > 
> > git clone git://repo.or.cz/geda-pcb/pcjc2.git
> > git checkout before_pours origin/before_pours
> 
> git checkout -b before_pours origin/before_pours
>               ^_____ Tells git to create a (local) branch

[snip]

> > (Then build as usual).

Since the latest code pushed (which has begun a slight refactoring), you
need to call configure with "--enable-gl" for it to look for and link
against the required OpenGL libraries and GtkGLExt.

NB: If you don't pass --enable-gl, the build fails.. I didn't yet get to
the point where the GL code in the GTK HID is conditionally compiled in.
At the moment, its more a GL fork of the GTK HID.

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user