gEDA-user: Pin pads on only one side

[Phil Frost <indigo@xxxxxxxxxxx>]

Is there some way to instruct PCB to put a copper pad for through-hole
pins only on the bottom of the board? I'm etching two sided boards, and
I don't solder to the top side since it makes rework much harder.
Sometimes the solder will travel down the lead and get to the top-side
pad, (which never connects to anything) making it very hard to desolder.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user