On Fri, 2011-01-21 at 14:01 -0500, Rob Butts wrote: > Here's a weird problem. I am using two inductors with the same > footprint in a small two layer design. After laying out the board > I > exported a ps version of the board. I then used ps2pdf to convert > the > layout for my printer. When I open the pdf document in windows the > layout looks exactly the way it should (all the foootprints are > correct). When I print out the etch patterns to make the board > both > pads for both inductor are missing even though they are there in > the > pdf! Could you send the .ps and / or .pdf versions of the board? It rather sounds like a bug with your PDF viewer's print facility, but we can take a look and make sure we're not emitting silly post-script which triggers it. -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me)
Attachment:
signature.asc
Description: This is a digitally signed message part
_______________________________________________ geda-user mailing list geda-user@xxxxxxxxxxxxxx http://www.seul.org/cgi-bin/mailman/listinfo/geda-user