gEDA-user: Fluky Fluky layout printing problem!

[Rob Butts <r.butts2@xxxxxxxxx>]

   Here's a weird problem.  I am using two inductors with the same
   footprint in a small two layer design.  After laying out the board I
   exported a ps version of the board.  I then used ps2pdf to convert the
   layout for my printer.  When I open the pdf document in windows the
   layout looks exactly the way it should (all the foootprints are
   correct).  When I print out the etch patterns to make the board both
   pads for both inductor are missing even though they are there in the
   pdf!
   Has anyone ever had this happen?
   Here is the foot print:
   Element ["" "" "" "" 10 10 -25000 -20000 0 100 ""]
   (
       Pad [-20650 0 -20642 0 11000 1200 1500 "" "1" "square"]
       Pad [20642 0 20650 0 11000 1200 1500 "" "2" "square"]
       ElementArc [0 0 25000 19650 250 40 100]
       ElementArc [0 0 25000 19650 70 40 100]
       ElementArc [0 0 10000 10000 0 360 100] #cirle
       ElementLine [-15000 -4900 -15000 4900 100] #inside verticle lines
   of pads
       ElementLine [15000 -4900 15000 4900 100]
       ElementLine [-24400 -4900 -15000 -4900 100] #bottom horizontal line
   of pad
       ElementLine [-24400 4900 -15000 4900 100]
       ElementLine [24400 -4900 15000 -4900 100] #top horizontal line of
   pad
       ElementLine [24400 4900 15000 4900 100]
       ElementLine [-24400 -9800 -24400 9800 100] #outside verticle lines
   of pads
       ElementLine [24400 -9800 24400 9800 100]
       ElementLine [-8500 -18000 -24400 -9800 100]
       ElementLine [8500 -18000 24400 -9800 100]
       ElementLine [-8500 18000 -24400 9800 100]
       ElementLine [8500 18000 24400 9800 100]
   )


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user