They are attached.
Thanks!
On Fri, Jan 21, 2011 at 2:08 PM, Peter Clifton <[1]pcjc2@xxxxxxxxx>
wrote:
On Fri, 2011-01-21 at 14:01 -0500, Rob Butts wrote:
> Here's a weird problem. I am using two inductors with the same
> footprint in a small two layer design. After laying out the board
> I
> exported a ps version of the board. I then used ps2pdf to convert
> the
> layout for my printer. When I open the pdf document in windows
the
> layout looks exactly the way it should (all the foootprints are
> correct). When I print out the etch patterns to make the board
> both
> pads for both inductor are missing even though they are there in
> the
> pdf!
Could you send the .ps and / or .pdf versions of the board?
It rather sounds like a bug with your PDF viewer's print facility,
but
we can take a look and make sure we're not emitting silly
post-script
which triggers it.
--
Peter Clifton
Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA
Tel: +44 (0)7729 980173 - (No signal in the lab!)
Tel: +44 (0)1223 748328 - (Shared lab phone, ask for me)
_______________________________________________
geda-user mailing list
[2]geda-user@xxxxxxxxxxxxxx
[3]http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
References
1. mailto:pcjc2@xxxxxxxxx
2. mailto:geda-user@xxxxxxxxxxxxxx
3. http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
Attachment:
board-2.ps
Description: PostScript document
Attachment:
board-2.pdf
Description: Adobe PDF document
_______________________________________________ geda-user mailing list geda-user@xxxxxxxxxxxxxx http://www.seul.org/cgi-bin/mailman/listinfo/geda-user