[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: gEDA-user: Ground plane question
> All I found was Settings->New lines, arcs clear polygon.
That's the setting.
> But that did not work: I had a board already routed
Well, those aren't *new* lines, those are *old* lines.
> and I tried placing a rectangle on the solder layer but it covered
> the routes and all I got was a full covered board...
You need to select all the lines and type
:ClrFlag(SelectedLines,join)
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user