Re: gEDA-user: Bug in cvs pcb concerning polygons

[lynx.abraxas@xxxxxxxxxx]

On 24/07/07 12:50:47, Ben Jackson wrote:
> On Tue, Jul 24, 2007 at 09:34:49PM +0200, lynx.abraxas@xxxxxxxxxx wrote:
> > 
> > Doing  my  first  board,  I  sadly  had  to  notice at the last steps that the
> > polygons and their clearance have a  bug.  At  some  point  of  layouting  the
> > copperlay  vanishes  partly or even fully even if there is no reason for it.
> 
> If you can point us at a board and a set of steps that would be very
> helpful.  I submitted a few bugs related to this after my last board and
> most of them I also have fixes for.

I have cvs pcb from today. The last stable version denies to open the file:(
Realoading doesn't help for me.

It's here: 
http://www-nw.uni-regensburg.de/~.grr06742.back.physik.uni-regensburg.de/PCB/GPS_BUG.PCB

If  I try to draw a copper rectangle on GND-comp it either doesn't draw one at
all or scrambles it in the lower left corner. Smaller areas work fine  though.
When  zooming it sometimes appears again but in the printout it's never right.
I get the messages :
Error while clipping PBO_SUB
Error while clipping PBO_UNITE

Changing pin-sizes made it worse in that area.


Lynx


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user