[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: gEDA-user: Mystery unrouteable rat in pcb ?
On 7/27/07, armdeveloper <armdeveloper@xxxxxxxxx> wrote:
> I had to hand route that because the footprint pin
> identifiers didn't match the symbol.
Hand routing is a very bad idea. You should create a set of symbols and
footprints that match so that your schematic and PCB are always in sync.
You could post a *simple* schematic and PCB that demostrate the
problem.
(* jcl *)
--
http://www.luciani.org
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user