[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: 1st pcb layout is missing components

Yes, I used JUMPER3.

I would say red.  I just realized I had to click in the board area and it placed all the parts in black.  Including the jumpers.

On Tue, Jul 22, 2008 at 6:08 PM, Peter Clifton <pcjc2@xxxxxxxxx> wrote:
On Tue, 2008-07-22 at 18:05 -0400, Robert Butts wrote:
> Actually, I did it on the qtouch.new.pcb file and it brought in the ic
> and rj45 but I'm still missing the 3 pin jumpers.  Also the ic and
> rj45 are in red.

What footprint did you use for the jumpers...

"JUMPER3" ought to work.

Red or orange?

Orange may indicate it thinks things are shorted against each other.
Move everything apart, then press "o" (optimise).

--
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user