Not everything in PCB can be included in an element. Specifically,
> I created a .8 mil ring, 4 arcs in a circle, in PCB. I then
> attached a via to the ring. Finally I copied everything to the
> buffer and did a Buffer>Convert buffer to element. I saved this as
> electrode.fp. I'd like to end up with a pin on a ring of copper and
> the solder mask covering the ring. How do I make sure the ring is
> made of copper? After I converted the buffer to an element it just
> showed a via with a pin number and a diamond where I positioned the
> mark in the center of the ring.
you may only include: vias, traces, rectangles, and silk lines/arcs.
Copper arcs and polygons may not be included.
For your case what you'll need to do is what I described earlier -
draw the ring with copper arcs *after* you place the element (just
pads) on the board. The ring will not be part of the element, but it
will work. You'll need a center pin or via to control the mask.
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
_______________________________________________ geda-user mailing list geda-user@xxxxxxxxxxxxxx http://www.seul.org/cgi-bin/mailman/listinfo/geda-user