Re: gEDA-user: geda-user Digest, Vol 26, Issue 50

[Vincent Onelli <vonelli@xxxxxxxxxxxxx>]

>> ------------------------------
>>
> Message: 6
> Date: Wed, 23 Jul 2008 15:51:12 +0100
> From: Peter Clifton <pcjc2@xxxxxxxxx>
> Subject: Re: gEDA-user: geda-user Digest, Vol 26, Issue 47
> To: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
> Message-ID: <1216824672.9717.33.camel@pcjc2lap>
> Content-Type: text/plain
>
> On Wed, 2008-07-23 at 14:49 -0400, Vincent Onelli wrote:
>
>> Thank you so mutch, this works
>> Here is another question, can I setup board size width and hight
>> larger than is need and then draw an outline for the proper size 
>> required? This
>> will  accomodate any shape board
>> Thank you again. Vinny
>
> Yes, just rename one of the layers "outline" (or add it as a new layer),
> and the right thing will happen.
>
> -- 
> Peter Clifton
>
> Electrical Engineering Division,
> Engineering Department,
> University of Cambridge,
> 9, JJ Thomson Avenue,
> Cambridge
> CB3 0FA
>
> Tel: +44 (0)7729 980173 - (No signal in the lab!)
>
Thank you
>
>
> ------------------------------



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user