Re: gEDA-user: Pin statement

["Mark Rages" <markrages@xxxxxxxxx>]

On Fri, Jul 25, 2008 at 9:46 PM, Kai-Martin Knaak <kmk@xxxxxxxxxxxxxxx> wrote:
> On Fri, 25 Jul 2008 15:09:14 -0400, Robert Butts wrote:
>
>> Will the Pin statement in the footprint definition below give me a 2.1
>> mm square hole with no copper annulus?
>     ^^^^^^
> How would a drill for square holes look like? ;-)
>

http://upper.us.edu/faculty/smith/reuleaux.htm

I'm not sure that my board house offers reuleaux drills, however.

Regards,
Mark
markrages@gmail


-- 
Mark Rages, Engineer
Midwest Telecine LLC
markrages@xxxxxxxxxxxxxxxxxxx


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user