[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: gnetlist -g PCB* (Re: gEDA-user: gEDA/PCB quick start tutorial?)
- To: geda-user@seul.org
- Subject: Re: gnetlist -g PCB* (Re: gEDA-user: gEDA/PCB quick start tutorial?)
- From: Mike Jarabek <mjarabek@istop.com>
- Date: Sat, 15 Jun 2002 12:00:50 -0400
- Delivered-To: archiver@seul.org
- Delivered-To: geda-user-outgoing@seul.org
- Delivered-To: geda-user@seul.org
- Delivery-Date: Sat, 15 Jun 2002 12:01:02 -0400
- References: <Pine.SOL.3.96.1020531082115.18300M-100000@bitter.mit.edu>
- Reply-To: geda-user@seul.org
- Sender: owner-geda-user@seul.org
mcmahill@mtl.mit.edu wrote:
> aha! Found the problem. gnet-PCBboard.scm has 'm4' hardcoded as the name
> of the m4 executible however, on my system 'm4' is the system m4 and 'gm4'
> is GNU m4. Perhaps there should be an autoconf test for GNU m4 to
> correctly set this name.
>
> Once I changed m4 to gm4, I get a .pcb file which looks much closer to
> being right (has my parts listed in it).
>
This is an old thread but, I ran into the same problem under FreeBSD.
--
--------------------------------------------------
Mike Jarabek
FPGA/ASIC Designer
http://www.doncaster.on.ca/~mjarabek
--------------------------------------------------