On Sat, 2010-06-05 at 19:45 +0200, Tamas Szabo wrote:
Hi,
I have to design a board full of leds and a few additional parts.
I already designed a similar board, but it wasn't necessary to made
schematic, since there was only 2 components excluding leds (one
connector, and a resistor). So I created a script to place the leds
automatically, and then I put the additional parts manually.
But no the case is somewhat different, since it is necessary to add more
parts to every line of led strings. So I need to create schematic as well.
I think all of you can feel that putting 600+ leds to schematic and
changing refdes manually is a _little bit_ boring:-) (And takes quite
long time.)
Did anyone have ever faced problem like this? Do any of you have idea or
a shareable tool for this purpose?
Should be 10 copy/past operations (1, 2, 4, 8, ... ) in gschem. And of
course recent gschem can renumber fine. Should be less work than writing
this mail, or do i miss something?
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user