Re: gEDA-user: PCB head fails with ***MEMORY-ERROR***

[Andrew Poelstra <asp11@xxxxxx>]

On Thu, Jun 02, 2011 at 11:45:01PM +0200, Kai-Martin Knaak wrote:
> Hi. 
> 
> A fresh clone from git of PCB just failed on me with memory error. While 
> I did some manual routing of a fairly large layout (~1700 components) the
> application died after several minutes. There was an error message on the 
> command line:
> 
> ***MEMORY-ERROR***: pcb-head[21193]: GSlice: failed to allocate 248 bytes (alignment: 256): 
> Cannot allocate memory
> 
> Anything I can do to help diagnose the problem, if this happens again?
>

Use gdb to get a backtrace (gdb ./pcb, then r to run, bt to backtrace).

-- 
Andrew Poelstra
Email: asp11 at sfu.ca OR apoelstra at wpsoftware.net
Web:   http://www.wpsoftware.net/andrew/



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user