gEDA-user: PCB head fails with ***MEMORY-ERROR***

[Kai-Martin Knaak <kmk@xxxxxxxxxxxx>]

Hi. 

A fresh clone from git of PCB just failed on me with memory error. While 
I did some manual routing of a fairly large layout (~1700 components) the
application died after several minutes. There was an error message on the 
command line:

***MEMORY-ERROR***: pcb-head[21193]: GSlice: failed to allocate 248 bytes (alignment: 256): 
Cannot allocate memory

Anything I can do to help diagnose the problem, if this happens again?

---<)kaimartin(>---
-- 
Kai-Martin Knaak
Email: kmk@xxxxxxxxxxxxxxx
Ãffentlicher PGP-SchlÃssel:
http://pool.sks-keyservers.net:11371/pks/lookup?search=0x6C0B9F53



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user