Re: gEDA-user: Double refdes

[Carlos Nieves Ónega <cnieves.mail@xxxxxxxxx>]

El lun, 06-03-2006 a las 16:29 +0100, Wojciech Kazubski escribiÃ:
> > > Is it possible to get warning or error when I have two resistors named
> > > R1 in my schematic? I always don't notice this and then get bullshit
> > > simulation.
> >
> > Doesn't DRC2 check for this?
> >
> Many DRCs does not detect this if both component have the same value. Old 
> Orcad was giving the warning that a component has two values. If they were 
> equal the program treated them as one component connected to both places.
> This is done to allow sloting (several components with the same refdes)
> Mayby it is possible to test if certain pin is used twice?

Check the drc2 backend. If you find a not included (and feasible) test
that can be done, I will happily try to add it.

Regards,

Carlos