Re: gEDA-user: random project idea

[DJ Delorie <dj@xxxxxxxxxxx>]

> 6/6 is doable if you slightly cheat the size of the solder pads.

The problem is the vias - a 12 mil hole with 6 mil rules is a 24 mil
via pad, with only 39 mil on center (1mm) that leaves 15 mil between
vias, which is enough for a 5/5 trace but not a 6/6 trace.

So with 6/6 rules, you're limited to the outer THREE rows, not the
outer FOUR.

Unless there's some trick for staggering the vias to make more room?


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user