[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: pcb, how to suppress TCL/TK QFP footprint builder?

To: geda-user@xxxxxxxxxxxxxx
Subject: Re: gEDA-user: pcb, how to suppress TCL/TK QFP footprint builder?
From: DJ Delorie <dj@xxxxxxxxxxx>
Date: Sun, 1 Mar 2009 17:14:00 -0500
Delivered-to: archiver@xxxxxxxx
Delivered-to: geda-user@xxxxxxxxxxxxxx
Delivery-date: Sun, 01 Mar 2009 17:14:08 -0500
In-reply-to: <1235945443.3910.63.camel@AMD64-X2> (message from Stefan Salewski on Sun, 01 Mar 2009 23:10:43 +0100)
List-archive: <http://www.seul.org/pipermail/geda-user>
List-help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-id: gEDA user mailing list <geda-user.moria.seul.org>
List-post: <mailto:geda-user@moria.seul.org>
List-subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
References: <1235945443.3910.63.camel@AMD64-X2>
Reply-to: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Sender: geda-user-bounces@xxxxxxxxxxxxxx

Either should work.  I think I use "true" so that Makefiles don't
fail.


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

References:
- gEDA-user: pcb, how to suppress TCL/TK QFP footprint builder?
  - From: Stefan Salewski

Prev by Author: Re: gEDA-user: PostScript output - moving off-center?
Next by Author: Re: gEDA-user: pcb printing
Previous by thread: gEDA-user: pcb, how to suppress TCL/TK QFP footprint builder?
Next by thread: Re: gEDA-user: pcb, how to suppress TCL/TK QFP footprint builder?
Index(es):
- Author
- Thread