[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: PCIe x1 connector footprints

On 3/8/11 11:04 PM, Darrell Harmon wrote:

http://dlharmon.com/~dlharmon/pciex1.pcb

This is a board with a PCIe x1 card edge. It is currently in my PC and
does fit properly. I thought you might want the outline too.

It uses the Altera Cyclone 4 GX FPGA. I currently have writes from the
host to the board working and should shortly have reads and DMA
working. I intend to release both the hardware and software under an
open license when it is done. A simple but high speed interface to the
PC is something that is not easily available at this time. I hope to
change that with this project.


  This sounds like a fantastic idea.  I'm look forward to it!

             -Dave

--
Dave McGuire
Port Charlotte, FL


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user