[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: SMT/Through Hole Mix

To: geda-user@xxxxxxxx
Subject: Re: gEDA-user: SMT/Through Hole Mix
From: DJ Delorie <dj@xxxxxxxxxxx>
Date: Tue, 16 May 2006 18:50:38 -0400
Delivered-to: archiver@seul.org
Delivered-to: geda-user-outgoing@seul.org
Delivered-to: geda-user@seul.org
Delivery-date: Tue, 16 May 2006 18:50:54 -0400
In-reply-to: <015e01c67937$62ed5140$1801000a@smzlx4fgpg74cx> (haoweibing@gmail.com)
References: <20060516135846.30DDB2AA07@earl-grey.cloud9.net> <015e01c67937$62ed5140$1801000a@smzlx4fgpg74cx>
Reply-to: geda-user@xxxxxxxx
Sender: owner-geda-user@xxxxxxxx

> I am interested on SMT board as well. For making only 1 or 2 prototype 
> board, my concern is that, for example, I need to buy a roll resistors which 
> at least are thousands of them. In addition, can I have some advises on what 
> tools are necessary for doing SMT board.

Digikey sells "cut tape" parts, which is just what it sounds like -
they cut them off the paper tape (rolls).  So if you order ten, you
get about two inches of paper with the SMT parts embedded in it.

References:
- Re: gEDA-user: SMT/Through Hole Mix
  - From: Stuart Brorson
- Re: gEDA-user: SMT/Through Hole Mix
  - From: hwb

Prev by Author: Re: gEDA-user: SMT/Through Hole Mix
Next by Author: Re: gEDA-user: Tragesym ROCKS
Previous by thread: Re: gEDA-user: SMT/Through Hole Mix
Next by thread: Re: gEDA-user: SMT/Through Hole Mix
Index(es):
- Author
- Thread