gEDA-user: Symbols again

[Ian Chapman <ichapman@xxxxxxxxxxxx>]

Hi and thanks for the last helpful suggestion that got me over a hump.

There are a few things that I am not clear on with symbols and
footprints.  Example built into the 7400.sym we have 

net=Vcc:14 and net-Gnd:7.  Yet when I click on the symbol on the
schematic I do not see this.  I am only curious as I wanted to change it
to 3.3V:14 without editing and creating a new symbol.

Second on a 9 pin sub min D I have pins 10 and 11 showing up as shorts
since I have connected the mounting pin/studs to ground.  Can I edit the
symbol on the schematic with net=Gnd:10 etc without hitting a snag?

The Net window was really good for de-snagging, I only had to select an
offending signal to see the connections then click a component to be
taken there.  The only snag was after flipping the board to see the
solder side it seems to go to the correct xy location for an un-flipped
board.  Thanks again for all the previous help Ian.



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user