[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: gEDA-user: A not too serious PCB question

To: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Subject: Re: gEDA-user: A not too serious PCB question
From: John Griessen <john@xxxxxxxxxxxxxx>
Date: Wed, 13 May 2009 09:49:48 -0500
Delivered-to: archiver@xxxxxxxx
Delivered-to: geda-user@xxxxxxxxxxxxxx
Delivery-date: Wed, 13 May 2009 10:50:02 -0400
In-reply-to: <1242224186.4870.13.camel@AMD64-X2>
List-archive: <http://www.seul.org/pipermail/geda-user>
List-help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-id: gEDA user mailing list <geda-user.moria.seul.org>
List-post: <mailto:geda-user@moria.seul.org>
List-subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
References: <1242224186.4870.13.camel@AMD64-X2>
Reply-to: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Sender: geda-user-bounces@xxxxxxxxxxxxxx
User-agent: Mozilla-Thunderbird 2.0.0.17 (X11/20081018)

Stefan Salewski wrote:

> http://www.mikrocontroller.net/attachment/50837/Beispiel.jpg

> This layout may have advantages if PCB is made mechanical, i.e. by
> milling machines.

That kind of layout has etchant cost minimization as advantage also.

John


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

References:
- gEDA-user: A not too serious PCB question
  - From: Stefan Salewski

Prev by Author: Re: gEDA-user: Signal Source Setup for Electric Guitar?
Next by Author: gEDA-user: translation standards (was: fritzing )
Previous by thread: Re: gEDA-user: A not too serious PCB question
Next by thread: Re: gEDA-user: A not too serious PCB question
Index(es):
- Author
- Thread