gEDA-user: How do I mark the connection point on a pad?

[Jim <jim@xxxxxxxxx>]

I'm not sure I'm saying that right.  What I've done is generate a set of 
pcb edge fingers using elongated pads, however when I run pcb, the 
ratsnest connects to the far end of the fingers, i. e. the part that 
goes into the socket.  That gives me no end of grief trying to route the 
board.  I've attempted to attach an image showing the problem. 

Thanks,
Jim.

_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user