Re: gEDA-user: gsch2pcb to pcb error

[Stefan Salewski <mail@xxxxxxxxxxxx>]

On Sat, 2010-05-29 at 11:31 -0700, Mike Bushroe wrote:

>       It looks like geda symbol nmos-2 uses pinnumber S,G,D instead of
>    1,2,3, and that might be causing some of my missing rat lines. 

Sure, Symbols and Footprints have to match, so use SDG in both, or 123
in both. I think SDG should indicate a generic one -- replace SDG by 123
in correct order matching your footprint and rename the symbol to the
name of the exact device name. That is what I did for some bipolar
devices, see my area a gedasymbols.
 
It seems that you had really much trouble -- more than me in the last 3
years since I started using gEDA/PCB. Maybe you can make a summary of
the most serious problems and someone can put that list in the wiki.
Unintended use of M4 macros seems to be one of your problems, I had that
problem long ago too, but I can not remember details.

Best regards

Stefan Salewski




_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user