Giorgenes Gelatti wrote:
>
> 2006/11/6, John Luciani <jluciani@xxxxxxxxx>:
>
>> On 11/6/06, Giorgenes Gelatti <giorgenes@xxxxxxxxx> wrote:
>> > I got a simpler circuit that is not working.
>> > I have snap turned on, but can't see a way of making it works :(
>> >
>>
>> What specifically isn't working?
>>
>> the netlist produced ---
>>
>> unnamed_net9 serial-2 pinbar-9
>> unnamed_net8 serial-1 pinbar-10
>> unnamed_net7 serial-4 pinbar-7
>> unnamed_net6 serial-6 pinbar-5
>> unnamed_net5 serial-8 pinbar-3
>> unnamed_net4 serial-3 pinbar-8
>> unnamed_net3 serial-5 pinbar-6
>> unnamed_net2 serial-7 pinbar-4
>> unnamed_net1 serial-9 pinbar-2
>>
>> which is all of the connections. I do not have the same set of
>> footprints so I
>> did not check out a PCB file.
>>
>> (* jcl *)
> In pcb the components are not connected. :-(
Did you open the .pcb file and then load the netlist and then press 'o'
(optimize rats)?
-Dan
_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user