[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

gEDA-user: SDIP ?

To: geda-user@xxxxxxxxxxxxxx
Subject: gEDA-user: SDIP ?
From: DJ Delorie <dj@xxxxxxxxxxx>
Date: Wed, 8 Nov 2006 00:26:51 -0500
Delivered-to: archiver@seul.org
Delivered-to: geda-user@moria.seul.org
Delivery-date: Wed, 08 Nov 2006 02:20:31 -0500
List-archive: <http://www.seul.org/pipermail/geda-user>
List-help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-id: gEDA user mailing list <geda-user.moria.seul.org>
List-post: <mailto:geda-user@moria.seul.org>
List-subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>, <mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
Reply-to: gEDA user mailing list <geda-user@xxxxxxxxxxxxxx>
Sender: geda-user-bounces@xxxxxxxxxxxxxx

Ok, I ordered a DIP-shaped R8C to experiment with, figuring I could
put it in a proto board.  Except, it turns out it's an SDIP (0.07"
pitch, instead of 0.10" pitch).  I get to fab an adapter board.

My question is: what's the deal with these?  Did we really need
something smaller than DIP without going to SMT?


_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

Prev by Author: Re: gEDA-user: furnace controller I/O port again
Next by Author: Re: gEDA-user: bug or feature in recent versions of PCB?
Previous by thread: gEDA-user: Open SDSL project mailing list
Next by thread: Re: Vendor FPGA tools (was Re: gEDA-user: Re: Pointer to 3d CAD?)
Index(es):
- Author
- Thread