Re: gEDA-user: Gerber view

[Peter Clifton <pcjc2@xxxxxxxxx>]

On Tue, 2007-11-13 at 09:19 -0500, Stuart Brorson wrote:
> To view a Gerber file, do a right mouse button on one of the numbered
> buttons on the right, then use the pop-up menu to open the Gerber file
> you want to see.  Then right mouse on the next button, and open the
> next layer, etc.

Stuart, you star!

I thought you had to load the layer stack from the command line!

I'd not got around to filing a feature request for a "File->Open", but
perhaps this might still be a useful at some point. Seems at least two
people now haven't realised it was possible to do via the layer-stack
buttons.

> When you are done, you can save your layer arrangement as a gerbv
> project.

That output is a nice touch.. I like it in gwave too.

Best wishes,

-- 
Peter Clifton

Electrical Engineering Division,
Engineering Department,
University of Cambridge,
9, JJ Thomson Avenue,
Cambridge
CB3 0FA

Tel: +44 (0)7729 980173 - (No signal in the lab!)



_______________________________________________
geda-user mailing list
geda-user@xxxxxxxxxxxxxx
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user